Panda Motorworks 124 Trade Center Drive https://cdn.shopify.com/s/files/1/0717/5893/files/PandaMain3_1800x512_crop_center.jpg?v=1578026447
ST. Peters, MO 63376
+1 (636) 614-3100

2016+ Honda Civic 1.5T Intercooler Upgrade Kit (Powdercoated Black)

$ 699.99

Fitment Notes:

  • FITS ALL 2016+ 1.5T HONDA CIVIC MODELS INCLUDING SI, NON-SI, 6MT, CVT, RHD, INTERNATIONAL MODELS, ETC
  • REMOVAL OF LOWER FACTORY INTAKE AIRBOX DAMPER IS RECOMMENDED FOR OPTIMAL FITMENT
  • FITS FACTORY CHARGE PIPING OR PAIR WITH OUR CHARGE PIPE UPGRADE KIT FOR OPTIMAL PERFORMANCE 

Please Read Before Ordering:

  • DOES NOT REQUIRE TUNE
  • THERE ARE (2) TOTAL O-RINGS IN THE FACTORY CHARGE PIPE SYSTEM. O-RINGS MAY BE SUBJECT TO REPLACEMENT IF TORN, DRY-ROTTED, DISFORMED OR HIGH MILEAGE

 

Technical Notes:

It’s no secret that Honda’s 1.5L turbo Civic is extremely susceptible to heat-soak, especially when retaining the factory intercooler. Excessive heat-soak increases the risk of detonation and causes major power loss due to high charge air and cylinder temperatures. These issues become even more prevalent with spirited driving and/or increased power outputs.

The PRL Motorsports intercooler upgrade decreases charge air temperatures while increasing potential airflow with its dense 550+ horsepower rated (though we have pushed 600+) 25.6x4x6.3” bar-and-plate bar-and-plate core and machined billet aluminum end tanks!

This intercooler utilizes factory mounting spots with our embossed end tanks. Kits will come with all hardware needed for a seamless install.

Kit Includes:

  • (1) Intercooler Assembly w/ Billet End Tanks
  • (2) Air Guides w/ Stainless Hardware
  • (2) Billet Aluminum Factory Charge Pipe Adapters
  • (1) Cardboard Stencil w/ “PRL” Logo
  • (2) PRL Factory Style Replacement O-Rings

 

Performance Gains:
  • 9 horsepower & 3 ft/lb torque gains by simply bolting on
  • 50+ F degree drop in post-charge air temperature at peak
  • Average of 36 F degree drop in post-charge air temperature
  • Increased efficiency & consistency in power delivery
  • Increased engine safety


If you plan to utilize the provided stencil to represent PRL on your intercooler:
-Clean and make sure your intercooler is dry.
-Place the cardboard stencil onto the front of the intercooler (Make sure the intercooler is not upside down, the PRL logo is on the driver's side end tank).
-It is recommended to tape down the stencil to have a sharp logo and to avoid moving.
-Mask off or cover the end tanks to avoid overspray.
-Apply a high temp engine enamel style spray paint (we recommend Duplicolor DE1635 Ford SemiGloss Black, any color can be used).
-Multiple coats may be needed to have full coverage, this varies per color.
-Allow drying 30-60 minutes before installing the intercooler.
-If any mistakes are made such as runs/overspray acetone or paint thinner can be used to remove any unwanted paint or to remove the stencil entirely, though this will take some time.